Mark II ejector ?

GMAN · Post by **GMAN** » Fri Aug 10, 2012 9:43 am

I have a mk II 22/45 and my ejector is pretty loose. Should I leave it or should it be tightened? The gun works just fine. (If it ain't broke, don't fix it?)

bearandoldman · Post by **bearandoldman** » Fri Aug 10, 2012 9:50 am

GMAN wrote:I have a mk II 22/45 and my ejector is pretty loose. Should I leave it or should it be tightened? The gun works just fine. (If it ain't broke, don't fix it?)

You answered your own question

blue68f100 · Post by **blue68f100** » Fri Aug 10, 2012 2:18 pm

It takes a special tool to set/tighten it up. So unless you start having problems I would not worry about it.

Post by **Bullseye** » Fri Aug 10, 2012 3:36 pm

If you start having ejection issues then you can tighten it up. It is fastened by a rivet, so either you buy a special seating and bucking tool, or use another method. I recommend using some high strength Loctite 271 sealant and a clamp. That would keep it tight during it's use. You just have to be sure that the ejector is seated properly when you bond it.

R,
Bullseye

GMAN · Post by **GMAN** » Fri Aug 10, 2012 7:22 pm

Thank's guys, I'm going to leave it alone. (If it ain't broke, don't fix it?)

GunTalk-Online.com

Mark II ejector ?

Mark II ejector ?

Re: Mark II ejector ?