The place to discuss the inner workings of firearms.
Moderators: Bullseye, Moderators
-
ruger22
- Master contributor
- Posts: 1574
- Joined: Mon Apr 13, 2009 10:35 pm
- Location: Virginia
Post
by ruger22 » Mon Jan 16, 2012 11:38 am
Hakaman wrote: The problem seems to be mounting the stirrup that holds the grip on.
Hakaman
The stirrup wouldn't quite fit my no-lock Single-Six. The stirrup would only fit sloppy in its upper hole, and the grip wouldn't pull up to the grip frame. There is a square frame cutout at the bottom of the grip frame, and filing the lowest corner a little larger worked. The stirrup is a snug fit in its lowest hole, and the grip fits good, with just a little backstrap set out.
The Monogrip is not very attractive, but useful at times.
* 2 Ruger Bearcat stainless, w/ EWK ejector housings & Wolff springs
* Ruger SP-101 .22LR, w/ Wolff springs
* 2 NAA Guardian .32ACP
* 3 Zastava M70 .32ACP
* S&W 15-22 Sport (.22LR AR)
* 2 Ruger SR22 .22LR pistols
-
Hakaman
- Master contributor
- Posts: 1940
- Joined: Thu Jan 15, 2009 8:51 pm
- Location: detroit, michigan
Post
by Hakaman » Mon Jan 16, 2012 2:47 pm
The stirrup wouldn't quite fit my no-lock Single-Six. The stirrup would only fit sloppy in its upper hole, and the grip wouldn't pull up to the grip frame. There is a square frame cutout at the bottom of the grip frame, and filing the lowest corner a little larger worked. The stirrup is a snug fit in its lowest hole, and the grip fits good, with just a little backstrap set out.
The Monogrip is not very attractive, but useful at times.
Would you be kind enough to attach some photos of your success mounting the stirrup/grips.
Thank,
haka
