I happened by one of my PawnShop haunts and stopped in
to see if they had any Marlin-60s or 10/22 that I needed...

And they had an interesting/nice looking critter in the rack...
a fairly new Tikka T3 Varmit in .308 (with an OK Bushnell x40 scope).
It is on an over-nite hold for me to make up my mind...
A. any "experience" with Tikka ?
I have aspirations to get a CZ-308, so this is a nice bump up (?)
B. any experience with Beretta (owner/importer) warranty svc ?
if there is some subtle troubles found later, will Beretta help out like Ruger?
C. It appears to be quite clean and the bolt-face / receiver show no powder/residue
just some "dust"... as if someone just needed to get some $$ back.
no nicks, scratches.. crown looks fine, bore is clean, bolt works well...
I'm thinking to try to get out the door for $M/2
any ideas, suggestions, things-to-check, experiences... Thanks.
I'm basically familiar with the rifle, I just have no experience with them.
I already had the links(below) and was out at Cabellys a few weeks ago
and held a couple of them along with CZs 550 (~30-caliber bore)...
it wasn't easy to keep the

off my face while I was looking at it...
Tikka.fi -and- Beretta-Tikka
EDIT 31Aug: well... turns out the scope is a Bushnell Elite 3200 10x40
so... it followed me home... When I stripped it for clean/inspect/lube...
it became a little bit obvious... it had NEVER BEEN FIRED...

now I can go "huntin' for some wabbits..."
