So there I was, installing the VQ accuracy kit, (trigger, sear, hammer and springs with a MKII bushing) on my MKIII. I wasn't familiar with the inner workings of the MKIII so I found the detailed install instructions over at Brownells. I followed them to the letter (iPad on my bench while working) only to find that my gun did not work!! I kept telling myself that the instructions failed to tie the sear and disconnector together BUT, I was following the instructions! I finally quit before I broke something, because this gun was not working!! I did an internet search and discovered Bullseye's detailed instructions... to include PLACING THE DISCONNECTOR BEHIND THE SEAR!! BANG... forgive my lack of experience with the Ruger but even I could figure out there HAD to be a tie in between the disconnector and the sear... but I was following directions... all be they incomplete!! Following Bullseye's detailed instructions , the gun went together... and it works!! Bullseye, if I ever have the pleasure of meeting you, the beer is on me!!
Ken
Thanks Bullseye
Moderators: Bullseye, Moderators