Not your typical MK II VQ sear question/observation

[new2mk2]

Hi all,

I recently purchaced a VQ sear kit from Midway. I thought it was drilled improperly because at a glance the sear seemed to have a small chip where they cut the slot, maybe measuring 1/32 of a inch running down the drilled hole. I returned it and got another one with a larger chip running down the drilled hole easily 1/16 of an inch where the slot was cut. I than came to the realization that this was probably normal even if the hole seemed to be a little oval. Is this normal? What kind of results, good or bad might happen in the difference? any thoughts is appreciated.

Best Regards

[Bullseye]

I'm having trouble visualizing the problem. How about a pic?

R,
Bullseye

[new2mk2]

Just some eye candy




Thanks Bullseye, Pls. forgive quality of pic

[Bullseye]

That is so wrong, send it back. You should call Nic Volquartsen and explain your situation. They must have a bad lot of sears if two look like that. There should be no chip outs on that surface.

R,
Bullseye

[new2mk2]

Thanks for your help Bullseye. Could you leave a ph. # or pm one to me?

Thanks Again

Best Regards

[Bullseye]

Volquatsen 712-792-4238

or [email protected]
[email protected]

They do answer the phone and follow up on customer inquires/complaints

R,
Bullseye

[new2mk2]

Thanks Bullseye,

I called and they are close and could not leave a message it seems, but I have e mailed Nic as you suggested.

Best Regards

[new2mk2]

Hi Bullseye,

Nic wrote back and apologizes for the inconvience, he said to mail it back so he could take a look and replace it.

Best Regards

[Bullseye]

They're very customer service oriented at VQ. Nic will make it right for you.

R,
Bullseye