Temptation

bgreenea3 · Post by **bgreenea3** » Sat Feb 08, 2014 3:56 pm

Bushings are cheap and fairly easy to fit. I would start there or replace the whole barely and buds hang with a "pre fit set" that about a c note or so.

bearandoldman · Post by **bearandoldman** » Sat Feb 08, 2014 3:59 pm

possibly the trigger operator need to be rejuvenated??????/

greener · Post by **greener** » Sat Feb 08, 2014 5:08 pm

The crown looked ok and the rifling looked ok. The barrel had a lot of play in the bushing. I didn't measure anything.

I may try painting the front sight but I don't think that will do much.

bgreenea3 · Post by **bgreenea3** » Sat Feb 08, 2014 6:44 pm

why stop at psinting the front sight? put some racing stripes on it.

greener · Post by **greener** » Sat Feb 08, 2014 10:23 pm

bearandoldman wrote:possibly the trigger operator need to be rejuvenated??????/

Rejuvenated? After decades of working to get this way?

bearandoldman · Post by **bearandoldman** » Sun Feb 09, 2014 9:42 am

greener wrote:
bearandoldman wrote:possibly the trigger operator need to be rejuvenated??????/
Rejuvenated? After decades of working to get this way?

Yes, it would be a lot of time wasted and it is too damn late to change. That I why /II stayed ORNERY AS I WAS.