bolt removal for winchester 121

derree · Post by **derree** » Sun Dec 11, 2011 4:38 pm

Cannot figure out how to remove the bolt to disassemble a winchester model 121. I pulled the trigger back but the bolt will not come out.

Post by **Bullseye** » Sun Dec 11, 2011 5:29 pm

As I recall, you have to remove the receiver from the stock. Once you do there's a small lever just in front of the trigger guard that you press forward as you pull the bolt rearward. By moving this lever forward it lowers the ejector which is what is keeping the bolt held in place.

Hope this helps.

R,
Bullseye

derree · Post by **derree** » Sun Dec 11, 2011 6:12 pm

Thanks a million Bullseye. It works! I sure appreciate the info---you saved the day!

Post by **Bullseye** » Sun Dec 11, 2011 8:28 pm

Glad it is solved for you!

R,
Bullseye