Page 1 of 1
Scope Mount Base
Posted: Fri Apr 16, 2010 9:18 am
by Dusky
Any suggestions on a good Scope Mount for a non drilled Mark II. I want to scope my 10".
Posted: Fri Apr 16, 2010 5:37 pm
by quick-draw
Do you plan on having your pistol drilled and tapped or are you thinking about a clamp-on mount?
Posted: Fri Apr 16, 2010 6:14 pm
by Dusky
I want to do a non drill and tap system. There isn't a gunsmith in this area that I would trust to drill and tap correctly.
Posted: Fri Apr 16, 2010 7:35 pm
by Bullseye
There's a couple of no-drill options. VQ makes a no-gunsmithing weaver rail
https://www.volquartsen.com/products/29 ... cope-mount. Jack Weigand makes a no-drill mount
http://www.jackweigand.com/rm2fd.html
Maryland Gun Works (MGW) makes one too.
http://www.mgwltd.com/firearms.shtml Although I believe you now have to order them through Brownells.
R,
Bullseye
no drill mount
Posted: Sun Jun 06, 2010 9:02 pm
by stewswanson
Put a weigand mount on my mk.3 6" stainless yesterday. The install went well although a little filing on the insert was neccessary. The plus side is that once it is made to fit the dovetail it is a very secure interferance fit.
I used an alluminum rod to remove the old sight and install the new insert with no damage to the pistol. Blue locktight was used on all parts and a Barska reflex sight went on the rail. So far all is well.
Stew