Page 1 of 1
Ruger MKIII 22/45 RP O.D. Grips
Posted: Sun Mar 07, 2010 10:35 pm
by TechTeach
This the first set and best place is on my RP
________
MARIJUANA STRAINS
Posted: Mon Mar 08, 2010 12:20 am
by Bullseye
Those are looking pretty good! I'd say you used the stock grips as a pattern for the mold. A good choice in my book.
I'd bet a set in Desert tan would look good too.
R,
Bullseye
Posted: Mon Mar 08, 2010 9:12 am
by oldpal
Are these grips the same thickness as the stock grips? Also, what's the material?
Hugh
Posted: Mon Mar 08, 2010 6:58 pm
by greener
I've looked at the RP at a couple of gun shows, and just haven't gotten the urge to get one. TechTeach's MKIII grips lessened the need. However, if the Techteach-RP grips are a tad thicker than the grips on the RP, I may be in the market for Ruger #6.
RP Grips
Posted: Thu Mar 11, 2010 6:18 pm
by TechTeach
I used the RP grips to make my molds going to make a set a little thicker to give the same thickness as my 1911 will post a picture when I have them made.
________
Smoke kills
Re: RP Grips
Posted: Mon Mar 29, 2010 6:33 pm
by tom234
TechTeach wrote:I used the RP grips to make my molds going to make a set a little thicker to give the same thickness as my 1911 will post a picture when I have them made.
Will the existing RP grip screws support thicker grips ? Are the grips screws stock 1911 or a common size that one can get longer ones ?
It would be nice to be able to add 1/8" steel shims under the existing grips to add more weight and get comparable 1911 thickness.