Discuss .22 pistols.
Moderators: Bullseye, Moderators
-
TechTeach
- New member
- Posts: 14
- Joined: Wed Dec 17, 2008 10:47 pm
- Location: Northwest Indiana
Post
by TechTeach » Sun Mar 07, 2010 10:35 pm
This the first set and best place is on my RP
________
MARIJUANA STRAINS
Last edited by
TechTeach on Tue Feb 15, 2011 11:12 pm, edited 1 time in total.
-
Bullseye
- Site Admin/Host
- Posts: 6384
- Joined: Sun Aug 14, 2005 12:23 pm
- Location: USA
Post
by Bullseye » Mon Mar 08, 2010 12:20 am
Those are looking pretty good! I'd say you used the stock grips as a pattern for the mold. A good choice in my book.
I'd bet a set in Desert tan would look good too.
R,
Bullseye
-
oldpal
- New member
- Posts: 27
- Joined: Tue Jan 26, 2010 12:06 pm
- Location: Augusta, GA
Post
by oldpal » Mon Mar 08, 2010 9:12 am
Are these grips the same thickness as the stock grips? Also, what's the material?
Hugh
-
greener
Post
by greener » Mon Mar 08, 2010 6:58 pm
I've looked at the RP at a couple of gun shows, and just haven't gotten the urge to get one. TechTeach's MKIII grips lessened the need. However, if the Techteach-RP grips are a tad thicker than the grips on the RP, I may be in the market for Ruger #6.
-
TechTeach
- New member
- Posts: 14
- Joined: Wed Dec 17, 2008 10:47 pm
- Location: Northwest Indiana
Post
by TechTeach » Thu Mar 11, 2010 6:18 pm
I used the RP grips to make my molds going to make a set a little thicker to give the same thickness as my 1911 will post a picture when I have them made.
________
Smoke kills
Last edited by
TechTeach on Tue Feb 15, 2011 11:12 pm, edited 1 time in total.
-
tom234
- New member
- Posts: 45
- Joined: Fri Aug 03, 2007 10:35 pm
- Location: Kansas
Post
by tom234 » Mon Mar 29, 2010 6:33 pm
TechTeach wrote:I used the RP grips to make my molds going to make a set a little thicker to give the same thickness as my 1911 will post a picture when I have them made.
Will the existing RP grip screws support thicker grips ? Are the grips screws stock 1911 or a common size that one can get longer ones ?
It would be nice to be able to add 1/8" steel shims under the existing grips to add more weight and get comparable 1911 thickness.
