GunTalk-Online.com

Posted: **Tue May 05, 2009 7:08 pm**

Mine isn't. It's almost painful to disengage the safety. So, how smooth is the operation of the manual safety on your Model 41?

Posted: **Tue May 05, 2009 7:20 pm**

Posted: **Tue May 05, 2009 9:30 pm**

Thank you.

Posted: **Wed May 06, 2009 3:26 pm**

Fixed it by simply backing off on the screw still leaving it snug. also oiled the sliding "thingie."

Posted: **Wed May 06, 2009 3:30 pm**

dapster wrote:Fixed it by simply backing off on the screw still leaving it snug. also oiled the sliding "thingie."

An unlubed "thingie" cause many problems, you just proved that theory again. Good luck and enjoy shooting.

Posted: **Wed May 06, 2009 3:42 pm**

It's important to use the appropriate technical nomenclature when possible, hence the use of "thingie."

Posted: **Wed May 06, 2009 3:51 pm**

dapster wrote:It's important to use the appropriate technical nomenclature when possible, hence the use of "thingie."

As and old service tech I will vouch for that. The thingie is the little doohickey right next to the whatsit, I think.

Model 41 Manual Safety - Is it Usable?