Page 1 of 1
MKIII 22/45 Trigger plunger spring??
Posted: Tue Mar 03, 2009 9:00 am
by copter_dad
Can anyone tell me how to identify the factory spring compared to the VQ spring? Gauge, length?
Re: MKIII 22/45 Trigger plunger spring??
Posted: Tue Mar 03, 2009 10:47 am
by bearandoldman
copter_dad wrote:Can anyone tell me how to identify the factory spring compared to the VQ spring? Gauge, length?
The VQ spring is a little weaker in compression, that about all I can tell you. Bullseye will probably know, for sure.
Posted: Wed Mar 04, 2009 5:07 pm
by Bullseye
If you mix them up it's hard to tell them apart. There's only four to six ounces difference between them.
R,
Bullseye
Posted: Wed Mar 04, 2009 5:31 pm
by bearandoldman
Bullseye wrote:If you mix them up it's hard to tell them apart. There's only four to six ounces difference between them.
R,
Bullseye
I know one is slightly less compression and how to tell the apart would be very difficult.