Page 1 of 1
Model 41 Factory Trigger Pull
Posted: Sun Oct 12, 2008 4:05 pm
by ChuckS1
What is the trigger weight set at the factory? I don't have a trigger pull gauge, but it seems heavier than my High Standard 107's 2.5 lbs. I'm the original owner (bought in 1986), so I know it hasn't been changed. The serial number (*******) says gun was built in 1984.
Posted: Tue Oct 14, 2008 6:17 am
by Bullseye
The factory trigger can be set anywhere from 2-3 lbs, depending where the adjuster bar is positioned within the frame. You can see more about adjusting the M-41's trigger weight here
http://www.guntalk-online.com/Model41ma ... trigadjust
R,
Bullseye
Posted: Wed Oct 15, 2008 7:45 pm
by ChuckS1
I know...that's why I want to find out what the factory trigger pull is. I guess I'll make a ghetto gauge with a plastic milk jug and some floss. An ounce of water still weighs an ounce, right?
Posted: Thu Oct 16, 2008 5:30 am
by Bullseye
Look at the little slide adjuster lever, each step represents 1/4 lb. If it is set in the middle then that is 2.5 lbs. If it is set on either end, then depending on where the trigger pivot pin sits its either 2 or 3 lbs. If you test the trigger weight and it is higher than 3 lbs., you may have something dragging on your trigger bar. On some pistols the slide can drag on this part, causing a higher than normal pull weight. A close inspection of the slide and the trigger bar can reveal where the friction may be, as these are a blued parts and any drag typically results in a shiny spot or wear in the bluing.
R,
Bullseye
Posted: Thu Oct 16, 2008 9:02 pm
by ChuckS1
Ghetto milk jug gauge says 2.7 lbs. Looked at your pictures on the tech page. Mine looks like it has two more clicks left at the end closest to the muzzle.
Posted: Thu Oct 16, 2008 10:15 pm
by Bullseye
Sounds like the adjuster is set right in the middle of the slide lever. Two pounds and eight ounces is exactly 2.5 lbs trigger weight, so your home made milk jug scale is pretty close. Your adjuster currently should look a lot like this one.
In order to lighten the pull, you want the slide lever forward, and move it towards the muzzle. That means the more steps toward the muzzle, the lighter the pull. Like this picture.
Two pounds is the legal limit for a legal NRA Rimfire Conventional Pistol (Bullseye Pistol)
Hope this helps.
R,
Bullseye
Posted: Fri Oct 17, 2008 5:11 pm
by ChuckS1
You are the man. Thanks for the advice and help.