VQ Trigger/Sear Question

greener · Post by **greener** » Sat Jul 19, 2008 11:04 pm

Locktite seems to have worked. No problems today.

Post by **Bullseye** » Sat Jul 19, 2008 11:09 pm

Great! That sealant should have solved it.

R,
Bullseye

bearandoldman · Post by **bearandoldman** » Sun Jul 20, 2008 6:48 am

greener wrote:Locktite seems to have worked. No problems today.

Most likely the only problem encountered was the dreaded TARGET SHIFT

greener · Post by **greener** » Sun Jul 20, 2008 4:06 pm

bearandoldman wrote:
greener wrote:Locktite seems to have worked. No problems today.

Most likely the only problem encountered was the dreaded TARGET SHIFT

I thought so. Thought I was doing a lousy job of not anticipating target jump. When I checked the target, it had a 1" hole in the center with daylight showing through it.

Then I realized I was in the wrong lane.

bearandoldman · Post by **bearandoldman** » Sun Jul 20, 2008 5:04 pm

greener wrote:
bearandoldman wrote:
greener wrote:Locktite seems to have worked. No problems today.

Most likely the only problem encountered was the dreaded TARGET SHIFT
I thought so. Thought I was doing a lousy job of not anticipating target jump. When I checked the target, it had a 1" hole in the center with daylight showing through it.

Then I realized I was in the wrong lane.

Either that or you were using a 10 gage slug aand just got lucky, Most of my off hand targets look like I was patterning my shotgun with #4 buck.

greener · Post by **greener** » Sun Jul 20, 2008 7:03 pm

Nope, that's precision shooting. Only a Master such as yourself can precisely match a shotgun pattern.