So far I've installed a VQ sear and a Clark bushing in my Ruger MkIII 22/45. I also bought a Clark trigger, but unfortunately the pin wont fit through it. I read that the installation process requires shaving metal off the front of the trigger, and drilling out the hole for the pin.
Unfortunately my power tool collection currently consists of one (1) dremel and I think I need a drill press to do this job correctly. Can it be done?
PS- This is my first post here. None of the upgrades I did would have been possible without the pictures Bullseye posted and the input from other members. After installing the bushing and sear my trigger pull is smooth and the break is crisp. The Clark trigger is my fix for a long pre travel. Thanks for the help, everyone.
DIY Clark Trigger Installation
Moderators: Bullseye, Moderators
-
blue68f100
- Master contributor
- Posts: 1997
- Joined: Mon May 25, 2009 10:31 pm
- Location: Piney Woods of East Texas
First, Welcome to Guntalk-Online.
To fit the trigger a number set of drill bits and drill press/end mill are the best way to fit the pin. Some have tried sanding the hole larger, but I do not much faith in that process. It may work if it try to fit but there is no way to keep every squared up. Small shaft with a slot to hold the paper is a common way to polish internals. If you go this way use fine sand papers (600+) so you control the removal process.
To fit the trigger a number set of drill bits and drill press/end mill are the best way to fit the pin. Some have tried sanding the hole larger, but I do not much faith in that process. It may work if it try to fit but there is no way to keep every squared up. Small shaft with a slot to hold the paper is a common way to polish internals. If you go this way use fine sand papers (600+) so you control the removal process.
David
SS MKIII 6 7/8" Fluted Hunter. Mueller Quick Shot, Bushnell 2x Scope, Hogue Rubber Grips
Custom Built 1911
SS MKIII 6 7/8" Fluted Hunter. Mueller Quick Shot, Bushnell 2x Scope, Hogue Rubber Grips
Custom Built 1911
I went with the Clark trigger based on recommendations I had read online. Supposedly it greatly improves pre-travel, takes out any side-to-side wobble, and I really wanted to try a "match" trigger... I've never shot a fancy trigger before.
Last night I went to the range. I was impressed by the difference. So far, so good.
Last night I went to the range. I was impressed by the difference. So far, so good.