Scope Mount Base

[Dusky]

Any suggestions on a good Scope Mount for a non drilled Mark II. I want to scope my 10".

[quick-draw]

Do you plan on having your pistol drilled and tapped or are you thinking about a clamp-on mount?

[Dusky]

I want to do a non drill and tap system. There isn't a gunsmith in this area that I would trust to drill and tap correctly.

[Bullseye]

There's a couple of no-drill options. VQ makes a no-gunsmithing weaver rail https://www.volquartsen.com/products/29 ... cope-mount. Jack Weigand makes a no-drill mount http://www.jackweigand.com/rm2fd.html
Maryland Gun Works (MGW) makes one too. http://www.mgwltd.com/firearms.shtml Although I believe you now have to order them through Brownells.

R,
Bullseye

[stewswanson]

Put a weigand mount on my mk.3 6" stainless yesterday. The install went well although a little filing on the insert was neccessary. The plus side is that once it is made to fit the dovetail it is a very secure interferance fit.
I used an alluminum rod to remove the old sight and install the new insert with no damage to the pistol. Blue locktight was used on all parts and a Barska reflex sight went on the rail. So far all is well.
Stew