V-Comp help

cheryld · Post by **cheryld** » Fri Feb 19, 2010 11:27 am

I just installed a V-Comp to my Ruger MKIII Hunter. After I shoot later this afternoon I will remove it to clean the buildup. What is the best way to do it? Also, does the O-ring need to be removed? If so, how does it come off? Thanks Cheryl

blue68f100 · Post by **blue68f100** » Fri Feb 19, 2010 12:42 pm

Spray it down with weld splatter spray before using it. It is a liquid to keep welding splatter from sticking and will make cleanup a lot easier. Then you can use your normal Hoppers #9 to clean it.

recumbent · Post by **recumbent** » Fri Feb 19, 2010 5:56 pm

The o ring doesn't need to come off. Splatter shield is a big help if you use it B4 you shoot it.

SD Handgunner · Post by **SD Handgunner** » Sat Feb 20, 2010 3:09 am

Does anyone know how much the Volquartsen V-Comp weighs and how long it is (ie how much does it add to the overall length of the Handgun)?

Thanks

Larry

recumbent · Post by **recumbent** » Sat Feb 20, 2010 7:15 am

SD Handgunner wrote:Does anyone know how much the Volquartsen V-Comp weighs and how long it is (ie how much does it add to the overall length of the Handgun)?

Thanks

Larry

the comp is over an inch in diameter and 2 1/4" long not sure what they weight.