GunTalk-Online.com

When I did my deep clean i forgot all about the Mag release. I took that appart today. There was all kinds of oil grease and metal shavings on the edge that catches the magazine. I cleaned it out and put the gun back together. The edge was actually cut below the pin. Now there is a gap between the e...

i found this comment on your troubleshooting site: Verify there is a 1/16" gap between the magazine feed lips and the ejector. If magazine feed lip is touching extractor, then lower the magazine's position by either taking a little material off of the plastic magazine bottom block or the magazine re...

thanks again bullseye i have a new project for the next time it rains.

thnaks for the advice Bullseye. I think i remeber there being a picture describing how to modify the magazine. but i cannot seem to find it using the search.

Wife was out of town this weekend so I did a detailed strip and deep clean of all the parts. After about 2 hours of cleaning and figuring out how to get the hammer and associated parts back in the gun i was ready to shoot. (Never would have been able to figure this out with out this site THANK YOU!!...

BOM, I am in Auburn Hills this week. Can i buy ammo in MI without an MI ID?

I have been having really bad luck with Winchester Super X HV and SV. lots of FTF. Problem is it is all I have and can't find anythign else right now.

I too broke down my Mark III for the first time this weekend. Thanks to all information on this website i had it disassembled cleaned, put back together and most importantly functioning in no time. Thanks everyone.

Has anyone used Dry Fire Dummies like the ones below? Was wondering if this would work for dry fire practice on my Mark III

http://www.midwayusa.com/viewProduct/?p ... ber=213850

My Wal-Mart only lets you buy 5 boxes of ammo a day. Still need to be there when it is put on the shelf.

I shot a couple hundred Winchester super X Standard velocity through my Mark III this weekend. I am a horrible shot so i cannot comment on accuracy. Only had 1 FTE. Seemed real dirty.

Are there any wear problems with shooting non-lead rounds through a Mark III or any other .22 pistol?

HAKA looks sweet. Shot my III competition target for the first time this weekend. Fun times. Can't wat to make these mods. What made you decide on the match dot over the other less expensive ultradots?

BOM The Peltor 10's you are referncing are those the Peltor H10A. So far i have been renting muff's and glasses but now that i made purchase it is silly to be wasting money renting when the gun cost so much.

Went to a gun show in Akron on Saturday. Wow it has been a long time since i have been to one. It takes all types. I finally bought my Mark iii GC. Shot it saturday as well. I love it. Not very accurate yet (i know that is all on me). i am away from home again this weekend in Indiana and can't wait ...

dont' put this junk in your Mark lll, they FTF i am in Indiana this week. I have been watching your posts as well. Never seen the spitfire ammo until today at Gander mountain. They had tons of it. they even had 9mm and .45. 9mm was at least double cost of what i paid at wallyworld last week at home.