Removing black finish from Bearcat hammer
Posted: Mon May 18, 2015 2:32 pm
I was changing my Bearcat spare parts from the coin envelopes they were shipped in four years ago, to zip locks. I noticed the hammer is all black, except bare brushed stainless on the sides. Then I noticed the part number didn't match the manual. It does start with a "K" confirming it's stainless. So I dug out the shipping invoice.
There is an asterisk next to the hammer part number, then it says "for use on stainless/blued guns". So it's a case of one part fits all.
So what sort of black finish would Ruger put on stainless, and how would I remove it if I ever use the hammer? The black areas that would be exposed on the gun have some gloss, but the rest is very dull.
There is an asterisk next to the hammer part number, then it says "for use on stainless/blued guns". So it's a case of one part fits all.
So what sort of black finish would Ruger put on stainless, and how would I remove it if I ever use the hammer? The black areas that would be exposed on the gun have some gloss, but the rest is very dull.