Page 1 of 1

target rifle bolt shims?

Posted: Thu Mar 19, 2015 1:11 pm
by cousin jack
I have an older 18XX Anschutz prone gun with a Hart Barrel that was installed long ago by Karl Kenyon..... this shim (sorry for the poor photo) was on the bolt, in front of that cylinder with the bolt handle attached. I assume it was a head space mechanism... the rifle shoots accurately without it, but it sometimes doesn't cock without forcibly slamming the bolt forward..... my question: The shim has a crack in it, and I was wondering if I should replace it.... do these things come in kits, somewhere, or was it one-off by Karl Kenyon? The barrel can't be head spaced normally because the action has been threaded. Any information or suggestions appreciated.

Image

Posted: Thu Mar 19, 2015 4:16 pm
by charlesb
I would take the shim to a machine shop with a lathe and see how much it would cost to have one made. Another tack would be to take measurements and see if it is a standard washer size.

Posted: Thu Mar 19, 2015 6:20 pm
by blue68f100
If it's only used as a shim the crack will not hurt, the thickness will be the same. Now if it's a preload/thrust spacer it should be replaced, but it does not appear to be..