MarkIII 22/45 Sear Spring

The place to discuss the inner workings of firearms.

Moderators: Bullseye, Moderators

Post Reply
Anchor
New member
New member
Posts: 15
Joined: Tue Dec 01, 2009 10:34 am
Location: Coupeville, Washington

MarkIII 22/45 Sear Spring

Post by Anchor » Wed Dec 16, 2009 9:44 am

I am new to this site so bare with me if this has been asked before. I have done a detailed strip of my MkIII 22/45 and have found the info here to be great. In starting to reassemble I find that the sear spring I have looks like nothing I have seen on these pages or at other sites. The long leg of the spring has two bends in it. The first is at about a forty degree angle and the second is at the end of the long leg. I would appreciate any assistance. Thanks.

User avatar
Bullseye
Site Admin/Host
Site Admin/Host
Posts: 6382
Joined: Sun Aug 14, 2005 12:23 pm
Location: USA

Post by Bullseye » Wed Dec 16, 2009 8:08 pm

Your sear spring for a 22/45 should look like the one pictured here (labeled 22/45)

Image

When placing one of these in the frame the long leg goes to the outside and the short leg is toward the inside. Follow the procedure here: http://www.guntalk-online.com/2245detai ... reassembly

R,
Bullseye
Image

Anchor
New member
New member
Posts: 15
Joined: Tue Dec 01, 2009 10:34 am
Location: Coupeville, Washington

Post by Anchor » Thu Dec 17, 2009 5:46 pm

Anchor,

This is the spring I removed from my Ruger. Thanks for your assistance.

Image

User avatar
Bullseye
Site Admin/Host
Site Admin/Host
Posts: 6382
Joined: Sun Aug 14, 2005 12:23 pm
Location: USA

Post by Bullseye » Thu Dec 17, 2009 6:35 pm

That 22/45 spring looks like it has been damaged, or to be more precise mangled. Looks like you need a new one.

R,
Bullseye
Image

Anchor
New member
New member
Posts: 15
Joined: Tue Dec 01, 2009 10:34 am
Location: Coupeville, Washington

Post by Anchor » Wed Dec 23, 2009 7:44 am

Bullseye,

Received new sear spring and installed it. All is well and will walk over to range today for a little practice. Thanks to you for the assistance.

Anchor

User avatar
Bullseye
Site Admin/Host
Site Admin/Host
Posts: 6382
Joined: Sun Aug 14, 2005 12:23 pm
Location: USA

Post by Bullseye » Wed Dec 23, 2009 9:02 am

Great! Just load two rounds at a time as a precaution until you're certain that the sear has the proper amount of spring tension on it from the spring.

R,
Bullseye
Image

Post Reply