The place to discuss the inner workings of firearms.
Moderators: Bullseye, Moderators
-
new2mk2
- New member
- Posts: 9
- Joined: Fri Oct 17, 2008 6:57 am
- Location: Georgia
Post
by new2mk2 » Fri Oct 31, 2008 10:37 pm
Hi all,
I recently purchaced a VQ sear kit from Midway. I thought it was drilled improperly because at a glance the sear seemed to have a small chip where they cut the slot, maybe measuring 1/32 of a inch running down the drilled hole. I returned it and got another one with a larger chip running down the drilled hole easily 1/16 of an inch where the slot was cut. I than came to the realization that this was probably normal even if the hole seemed to be a little oval. Is this normal? What kind of results, good or bad might happen in the difference? any thoughts is appreciated.
Best Regards
-
Bullseye
- Site Admin/Host
- Posts: 6382
- Joined: Sun Aug 14, 2005 12:23 pm
- Location: USA
Post
by Bullseye » Sat Nov 01, 2008 7:32 pm
I'm having trouble visualizing the problem. How about a pic?
R,
Bullseye
-
new2mk2
- New member
- Posts: 9
- Joined: Fri Oct 17, 2008 6:57 am
- Location: Georgia
Post
by new2mk2 » Sun Nov 02, 2008 9:40 am
Just some eye candy
Thanks Bullseye, Pls. forgive quality of pic
-
Bullseye
- Site Admin/Host
- Posts: 6382
- Joined: Sun Aug 14, 2005 12:23 pm
- Location: USA
Post
by Bullseye » Sun Nov 02, 2008 10:46 am
That is so wrong, send it back. You should call Nic Volquartsen and explain your situation. They must have a bad lot of sears if two look like that. There should be no chip outs on that surface.
R,
Bullseye
-
new2mk2
- New member
- Posts: 9
- Joined: Fri Oct 17, 2008 6:57 am
- Location: Georgia
Post
by new2mk2 » Sun Nov 02, 2008 10:58 am
Thanks for your help Bullseye. Could you leave a ph. # or pm one to me?
Thanks Again
Best Regards
-
new2mk2
- New member
- Posts: 9
- Joined: Fri Oct 17, 2008 6:57 am
- Location: Georgia
Post
by new2mk2 » Sun Nov 02, 2008 11:41 am
Thanks Bullseye,
I called and they are close and could not leave a message it seems, but I have e mailed Nic as you suggested.
Best Regards
-
new2mk2
- New member
- Posts: 9
- Joined: Fri Oct 17, 2008 6:57 am
- Location: Georgia
Post
by new2mk2 » Mon Nov 03, 2008 11:37 am
Hi Bullseye,
Nic wrote back and apologizes for the inconvience, he said to mail it back so he could take a look and replace it.
Best Regards
-
Bullseye
- Site Admin/Host
- Posts: 6382
- Joined: Sun Aug 14, 2005 12:23 pm
- Location: USA
Post
by Bullseye » Mon Nov 03, 2008 5:41 pm
They're very customer service oriented at VQ. Nic will make it right for you.
R,
Bullseye