DA revolver frame lugs

The place to discuss the inner workings of firearms.

Moderators: Bullseye, Moderators

User avatar
ruger22
Master contributor
Master contributor
Posts: 1553
Joined: Mon Apr 13, 2009 10:35 pm
Location: Virginia

DA revolver frame lugs

Postby ruger22 » Sat Mar 18, 2017 12:21 pm

A chance for our fearless leader and expert gunsmith to get technical.

By frame lug, I mean the the tiny bump on the frame below the cylinder release that keeps the cylinder from sliding completely off the crane when open. Specifically, I've noticed that my SP-101s have it, but the GP-100 doesn't, even though they are basically the same design. Nether does the Redhawk. The Six series revolvers don't have it either. I wonder that when they shrunk the GP to create the SP, could they have kept that the same?

I find it a bit disconcerting that a tiny bump of steel that overlaps the cylinder by maybe 1/32nd of an inch is all that keeps it off the floor. It gets slammed by the cylinder every time you eject empties. One area where the SP is not "built like a tank", as people say.

How likely is it to become a problem? I've heard of problems with S&Ws that have it. What would Ruger do to correct it since the lug is part of the frame?

EDIT: It's not shown well in the manuals, but thanks to YouTube, I know the difference. The GP and Redhawk have two spring loaded balls at the front of the crane. They ride in a groove inside the cylinder. The cylinder just snaps on and off of those balls. Seems the SP could be the same, still. The older Six series just had the ejector rod screw into the ejector, trapping the cylinder in between. I sometimes miss my Speed-Six; would have another if Ruger still serviced them.
*2 Bearcat stainless, w/ EWK ejector housings & Wolff springs
*SP-101 .22LR, w/ Wolff springs
*SP-101 .357 snub w/ Wolff springs
*10/22 Deluxe Sporter, unmodded!

Return to “Technical Forum”

Who is online

Users browsing this forum: No registered users and 2 guests