3 stage trigger on my Ruger 22/45.....
Posted: Wed Feb 18, 2015 4:35 pm
I have a 22/45 with a Volquartzen accuracy kit..... I did have a Volquartzen trigger in it, too, but it started not cocking, and when I tried to back the pre-travel screw out, the tool socket stripped.... (I think I used finger nail polish to cement the screw in). We tried drilling it from the rear, and it didn't break free....so we drilled it the rest of the way out. Not enough metal left now to thread the remaining hole, so I reinstalled the factory trigger. And that solved the "failure to cock" issue, but.....
I now have a three stage trigger: take up the first stage, then a tiny, rough, "get ready" stage, and then the gun goes off..... screws me up on sustained fire.... Question: is there anything that can be done about this damned middle, "better-get-ready" stage? I didn't notice it so much with the Volq trigger in..... Don't want to spend $50 on another trigger! Might just reinstall the Volq trigger without the pretravel screw.....
I now have a three stage trigger: take up the first stage, then a tiny, rough, "get ready" stage, and then the gun goes off..... screws me up on sustained fire.... Question: is there anything that can be done about this damned middle, "better-get-ready" stage? I didn't notice it so much with the Volq trigger in..... Don't want to spend $50 on another trigger! Might just reinstall the Volq trigger without the pretravel screw.....