Search found 8 matches
- Sun Jun 29, 2014 1:59 pm
- Forum: The Workshop
- Topic: DIY Mark III mag safety removal spacer washers
- Replies: 21
- Views: 89755
22/45 cross pin removal
Hi, I did this mod about 5 years ago on a MK III, and I didn't have a problem. Now, trying to repeat this on a 22/45, I can't get the hammer bushing pin out. I've hit them pretty hard with a punch too. Being a plastic gun, I'm a little concerned with breaking the frame. Is there a particular directi...
- Fri Nov 27, 2009 8:46 pm
- Forum: Rimfire Handguns
- Topic: Screw size, MK III
- Replies: 8
- Views: 5876
- Thu Nov 26, 2009 5:45 pm
- Forum: Rimfire Handguns
- Topic: Screw size, MK III
- Replies: 8
- Views: 5876
- Sun Nov 22, 2009 1:38 pm
- Forum: Rimfire Handguns
- Topic: Screw size, MK III
- Replies: 8
- Views: 5876
- Fri Nov 20, 2009 6:19 pm
- Forum: Rimfire Handguns
- Topic: Screw size, MK III
- Replies: 8
- Views: 5876
Screw size, MK III
I know I've seen this before, but I'm looking for the size of the rail mounting screws on a MK III. #6-40?? How hard is it to drill these screws? Is the receiver hardened? I've got a Standard that I am thinking of putting a rail on so I can attach a red dot scope. I've got a drill press. Thanks, Jeff
- Fri Oct 02, 2009 3:06 pm
- Forum: Rimfire Rifles
- Topic: Marlin 60 new vs old, FTE
- Replies: 4
- Views: 5923
Thanks for the answers here. Unfortunately, it wasn't as simple as mis-assembly... To simplify, My original problem was a failure to eject. I replaced the extractors and their springs. Then, because I was now getting total failure to eject, I replaced the feed throat and the lifter spring with more ...
- Tue Sep 29, 2009 9:08 pm
- Forum: Rimfire Rifles
- Topic: Marlin 60 new vs old, FTE
- Replies: 4
- Views: 5923
Marlin 60 new vs old, FTE
Hi, I have a Marlin 60 (actually a Western Auto 120), that I think is a 1973 model. I've had it for about 8 years, but am just trying to figure it out. I am getting about 1/2 failure to ejects! Since the extractors seemed weak, I replaced them. The cartridges do not seem to be ejected. The previous ...
- Thu Jul 02, 2009 2:17 pm
- Forum: Marksmanship Forum
- Topic: Target measurement
- Replies: 3
- Views: 5321
Target measurement
Hi, Please excuse me if this has been answered before, but how does one measure a target? How does one measure the distance between two hits? Is it center to center, or inside edge to inside edge, or outside edge to outside edge, or ?? I assume the holes are measured as the size of the bullet hole i...